bLighTnetWorK

send something by light

this screen can pass a small message to a phone using only light. no wifi, no pairing, nothing to install.

nothing crosses a network. the light stays in the room.

these are sample messages. their signatures say preview; nothing is signed for real.

the necklace

bcomb://mono-v2
luminance only · no network · loops until stopped · one screen, any number of cameras
hue carries 0 bits · the decoder never reads a colourrim + halo = decoration

geometry · flat-top axial hex, 6 rings

ringrolecells

frame · one comb, one frame

#fieldbits

payloads · tap to choose

#kind · bytesframes

beam pipeline

    receipt · this beam

    verify · no camera needed
      the beam below ↓ fork the template ↗opens in a new tab

      the whole beam

      bLighTnetWorK · the bLiGhTbeAM

      The logo is the transmission. Every lit hexagon is one bit of the live frame; the lit rim carries none. ~588 b/sec · no network · no pairing · no install.

      Ready to beam.
      Press send — the beam then runs until you stop it, so there is time to pick up your phone and aim.
      1 · press send 2 · pick up your phone 3 · open the BNR receiver 4 · aim at the beam
      Idle.
      Receiver a BNR dApp catching the beam

      bNature · dApp shell

      Waiting for a beam…
      Ear listen for the other device's answer
      Demo link This panel receives frames in-page, so the protocol is visible without a second device. A real phone decodes the identical bytes — in QR mode today, in bComb once the bcomb decoder ships.
      [bLighTnetWorK] ready.
      ⌂ hub